UCS: Blade is stuck after replace CMOS battery

[jalmishal]

Hi Expert

I have a B230 M2 blade server, it was working fine. but I got error that "CMOS battery voltage: Lower Non Critical"

I replaced the CMOS battery (CR2302)  now the server seems is stuck with

Cisco System, Inc.

Configuring and testing memory, please wait ...

Please see the attached screen shoot.

also in general now I see this error

Operating Memory Voltage: Low Voltage

Any ideas to try next?

to bringing the blade server back to service.

I also try to enter the BOIS pressing (F2),  Del . with no luck . 

Thanks,

[Kirk J]

If it is currently hung at post, then I would reseat all the DIMMs (maybe one got bumped when doing CMOS battery).

Also, reset CMOS via 'recover' server.

Aside from that, would need to see logs from tech support to get details.

Kirk...