So I have two of these in 2951s that are not booting (against three more that are). The CIMC is not coming up at all.
The power LED on the module is amber and blinking. The router itself seems fine (although I'm not doing much with it besides configuring the E140D).
2951router#ucse 2 status
Service Module is Cisco ucse2/0
Service Module supports session via TTY line 131
Service Module is waiting for registration message
Service Module reset on error is disabled
Service Module heartbeat-reset is disabled
I've tried resetting the blade both from the console ("ucse 2 reset" and stop and start as well) and physically without any luck. Any suggestions?
