Upgrade to ESXi 7.0.3n on B200 M4's MISSING DEPENDANCY VIBS errors

[dbutch1976]

Hello,

I am working on some legacy gear which we do not have support for but are not ready to decommission. Two questions:
Questions 1:
Our FI's and blade are running on older firmware: 
4.0(4d)
Which does appears does not support 7.0.3, but is this irrelevant since we don't have support in any case? 
 Cisco UCS Hardware Compatibility List

Question 2:
When attempting to upgrade by mounting the ISO directly I have a series of missing VIB errors. I understand that typically I would just remove these VIBs, but how can I confirm that these VIBs are actually not in use by our hardware?

[Riaan van Niekerk]

1. Was this server initially installed with ESXi 5.5 or 6.0 Cisco custom images?
2. Are you upgrading from ESXi 6.7?
3. Are you trying to upgrade using the non-custom image?

These VIBs all have 5.5 and 6.0 in the VIB name.

From my experience, VIBs like this are left behind from older installs, may be compatible with the current version, but not the version you are trying to upgrade to; and the new version does not contain newer versions of these VIBs. I would try upgrading using the latest ESXi 7.0 Cisco custom offline bundle (the Cisco custom ISO is only supported for new installs. If that does not work, I would suggest removing the VIBs.

If you are booting from SAN, you need the FNIC driver only, which the upgrade error message does not complain about. The ESXi 7.0 bundle should contain all drivers for all hardware Cisco hardware supported and certified with ESXi 7.0.