Virtual MAC-Address on Solaris 10 update 9
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-16-2012 06:25 AM - edited 03-01-2019 10:19 AM
Hi,
i'm installing Solaris 10 update 9 on UCS B-Series (B230 M2 or B440 M2) with M72KR-Q Adapter. We create the Service Profile with vNIC associated to vNIC Template. The vNIC Template use the MAC Pool Address configurated.
When we run ifconfig -a on Solaris we can view only the original MAC-Address instead of Virtual MAC-Addres. Is this correct?
Thanks in advance
- Labels:
-
Unified Computing System (UCS)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-16-2012 07:37 AM
Hello,
I've no M72KR-Q adapter in my lab so i can't test it but i think you can't create vNICs or vHBAs with this card.
I think you can create vNics and vHBAs only with adapter like M81KR.
However, my answer must be verified by Cisco.
Florent
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-16-2012 07:57 AM
Hi Florent,
with M72KR-Q you can virtualize only 2 vNICs and 2 vHBA.
Follow this link, at figure 2:
http://www.cisco.com/en/US/prod/collateral/ps10265/ps10493/data_sheet_c78-623738.html
So, it's strange that Solaris can recognize Virtual WWPN but not Virtual MAC ADDRESS.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-16-2012 08:11 AM
When you say the "original" MAC are you referring to the Hardware Default?
Ensure your MAC pool has available addresses also. You can also test unbinding the vNIC template from the Solaris service profile, and manually assigning a MAC address (watch for overlap) to the vNIC and see if that pushes to the solaris host.
If that works, then you have a pool/template issue. If not, we'll need to investigate further.
Regards,
Robert
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-16-2012 08:59 AM
Hi,
the MAC pool is not empty. I tried to unbinding the vNIC from vNIC Template and I tried to assign MAC Address manually but Solaris can't view Virtual MAC Address, we have only original MAC Address.
