[Cross posting to Nexus 1000V and UCS forums]Hi all, I have a working setup of UCS 1.4 (3i) and Nexus 1000V 1.4 and as per the best practice guide am using 'channel-group auto mode on mac-pinning' on the Nexus uplinks. I am having trouble when adding...
Hello all,1. We have set up 3 VSAN's for the customer here (100-102). Our design has connectivity from the MDS 9148 to the Fabric Interconnect 6120's, however they are not redundant connections (4 FC connections each). Because of this, I created V...
Hi, need some expert advice here.My client has a Nexus 1010 currently. It is loaded with Cisco NAM Virtual Service Blade Software 4.2.Recently, they have decided to purchase another Nexus 1010 as a standby node.My key question is do they have to purc...
Anyone run in to an issue where after applying to 7 servers, the firmware policy won't apply anymore? I can't hit the drop down menu for the firmware policy anymore. even on the servers that HAVE the new policy. It is greyed out. Is there a limit...
Good Day, we have a UCS 200 and we tri many time to install WIN server 2008 ent.but every time we face a problem, which " we get a error massage that is the computer restarted unexpectedly or encountered an unexpected error. Windowos installation...
Hello,This will be our first deployment using UCS 2.x with 5108/B200/6248UP/M81KR Cisco hardware with an EMC VNX5100 directly connected to the Interconnects.I was wondering if anyone had a cheat sheet/cookbook for these boot from SAN architectures? T...
Hello, I have 2 ucs 6120XP clustered and I cannot access them remotely. Routing is OK, local ping is OK, but when I try to ping the virtual IP address or the management ip for each unit there is no response.Any hints?Regards,Alex Torres
