Buy or Renew
Buy or Renew
NOTICE: You can now engage in the community. Learn about the great new Cisco Umbrella content.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1594
Views
0
Helpful
1
Replies

VSAN Configuration Connecting to Brocade Fabric

dturner8159
Level 1
Level 1

‎07-19-2011 07:38 PM - edited ‎03-01-2019 09:59 AM

Hi All,

I'm connecting UCS 6120 fabric interconnects to 2 Brocade FC fabrics.  Should I configure VSANs on the 6120's (I don't think Brocade supports them), or just use the default VSAN1?

Thanks.

0 Helpful
1 Reply 1

Robert Burns
Cisco Employee
Cisco Employee

‎07-19-2011 07:40 PM

You're correct.  The brocade has no concept of VSAN.  Just use the default VSAN 1. Also ensure the brocade has NPIV enabled.

Regards,

Robert

0 Helpful
Customers Also Viewed These Support Documents

Review Cisco Networking for a $25 gift card

Review Cisco Networking for a $25 gift card