10-14-2011 06:53 AM - edited 03-01-2019 10:06 AM
i have installed windows 2008 R2 on a B440 M2 and having issues with the network. not able to ping even the default gateway or any other servers on the same network/vlan
an esx server in the same VLAN works fine.
i know this is only partial information, but was wondering if there was some config off the top that i am missing
p.s. my chassis has the palo card
Solved! Go to Solution.
10-14-2011 07:14 AM
The most common issue I see in this instance is that the servrice profile associated with Windows does not have the associated vlan marked as native.
- Confirm the service profile has the appropiate vlan
- Confirm the vlan is marked as native
- Can the windows OS ping other hosts on the same subet in the same UCS chassis
- Is there an impact if you force traffic over fabric A or B.
HTH,
Dan
10-14-2011 07:14 AM
The most common issue I see in this instance is that the servrice profile associated with Windows does not have the associated vlan marked as native.
- Confirm the service profile has the appropiate vlan
- Confirm the vlan is marked as native
- Can the windows OS ping other hosts on the same subet in the same UCS chassis
- Is there an impact if you force traffic over fabric A or B.
HTH,
Dan
10-14-2011 07:24 AM
that worked !!!!
i had not marked the VLAN as native
thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: