11-02-2016 04:44 AM - edited 03-01-2019 12:57 PM
Hi
I have 5 blades B200M4 and all blades has active zoneset on fabric interconnect
all servers virtualized with vSphere ESXi
all servers see the storage except one of them, we try to scan the storage but could not although the zoneset is active
any opinion?
11-02-2016 04:55 AM
Greetings.
Are you in FC switching mode? Is your storage direct attached to the FIs?
Please run the following on each FI:
#connect nxos
#show flogi database vsan vsan ID
If you are in end host mode for FC run:
#connect nxos
#show npv flogi-table
If your initiators appear to be flogi'd in correctly,, then you'll want to recheck your storage permissions/masking where you assign/allow initiator wwpns to access the luns/storage groups.
Thanks,
Kirk...
11-02-2016 05:37 AM
yes FC switching mode
yes direct connect Netapp FAS 2552 to FI
we solve it, it's storage issue
11-02-2016 05:37 AM
Your output appears to show 5 initiators, and the storage target successfully flogi'd in.
For the problem server, you will want to review the storage group/lun permissions on the Storage admin app, and make sure there are no typos for the permissions where you have assigned the initiator's wwpn to the storage group/LUN.
Thanks,
Kirk
11-02-2016 05:42 AM
Hello,
I agree with Kirk, everything is logging in correctly. I would ensure you have the correct LUN masking setup on the storage array. Check the ports and make sure they are all allowed to access the correct zones.
HTH,
Wes
11-02-2016 05:52 AM
thank you Kirk
thank you Wesley
it's storage issue, the LUN not masking and the server removed from the initiator group
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide