Cisco UCS and Puppet have put together a new solution for rapid bare metal provisioning in just a few steps. Provisioning is done through Puppet's Razor module which offers a variety of options for installing host environments on provisioned nodes. In this example, Service Profiles are used to configure all aspects of the infrastructure and they define the role of the provisioned node simply by naming the Profile to match a role defined within Puppet. Checkout the Puppet on UCS communities page for more info.
Hello All, I have one UCS B200 M3 blade with a predictive HDD failure. <faultInst
descr="Local disk 1 on server 2/6 operability: degraded. Reason: D...
Hi There,Cisco UCS 6248UP fabric interconnect comes with 12 ports Right to Use licenses. Also the latest firmware for UCS is available for download. Could you let me know if I am allowed to download and install the latest firmware & use the 12 li...
i have installed two numbers of cisco VIC 1385 card on UCS C240M5 server but in CIMC VIC adapter section only one card is listed. i have installed the cards in slot number 4 & 5. in VIC adapter section only slot 5 is showing. In PCI adapter i could se...
Hi everyone, We're purchased new UCSC-C220-M5SX server running 2 separated CPUs and using 2 UCS-M2-240GB in back slot as local storage. After following embedded raid config and driver download in link, wewas successfully created raid 1 virtual driver...
Hello team, We are unable to install Ubuntu 14 04 on Cisco UCS C240 M5 server which has RAID configuration. RAID Controller Info: RAID bus controller: LSI Logic / Symbios Logic MegaRAID Tri-Mode SAS3516 (rev 01) We are unable to find d...