IP source routing must be disabled

[MOHAN.RAJ1]

Hi Team 

I needs to disable the IP source routing must be disable on ucsmanager. can you please anyone tell me where i can disable it.

If we disable may i know what impact we will get.

Thanks in Advance

Mohan

[Marcin Latosiewicz]

UCS/Fabric Interconnects are not routing devices. The operate either in end host or FC/Ether switching modes (the former being recommended for most deployments). 

[MOHAN.RAJ1]

Hi Marcin

Thanks for clarifying. as per understanding from your update ip routing feature will not be available on fabric interconnect correct.

Thanks in Advance

Mohan.

[Marcin Latosiewicz · Accepted solution]

Mohan, 

But there is no data plane routing on FIs, NXOS. Let me demonstrate. 

bdsol-6296-01-B(nxos)# show ip route 
IP Route Table for VRF "default
'*' denotes best ucast next-hop
'**' denotes best mcast next-hop
'[x/y]' denotes [preference/metric]

bdsol-6296-01-B(nxos)# show ip route vrf management 
No IP Route Table for VRF "management"
bdsol-6296-01-B(nxos)# sh run int mgmt 0

!Command: show running-config interface mgmt0
!Time: Fri Oct 16 11:02:50 2015
version 5.2(3)N2(2.23d)
interface mgmt0
  shutdown force
  ip address 10.48.43.82/25

Hope that clears things up.

M.

[MOHAN.RAJ1]

Hi Marcin

Thanks alot clarifying detaily.Its makes me more sense.

Regards

Mohan.