USC C220 M4 PowerCycling

[Itami]

 Hello,

I bought a USC C220 M4 and installed the following components:

2 x Intel XEON e5 2696 v4,

8 x DDR4 ECC REG 16GB

The problem is that the system keeps powercycling when I try to boot the system.

While the system is booting the system status LED is amber but none of the error leds inside of the chassis is lighted.

I hope someone can help me or show me how to diagnose the problem.

[marce1000]

 - Ref : https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/c/hw/C220M4/install/C220M4/replace.html

                          Check Table 3-1

 M.

[Itami]

Hello,

thank you for your answer, but I already visited this page.

I think the used CPU is not supported, but until now I could not verify that.

T.

[Kirk J]

Yea, don't see that specific processor in the spec sheet at https://www.cisco.com/c/dam/en/us/products/collateral/servers-unified-computing/ucs-c-series-rack-servers/c220m4-sff-spec-sheet.pdf

Kirk...