About Harold Ritter

Harold Ritter · 07-31-2013

Hi everybody,I just received this from a customer, who thinks this might be a record uptime for a Cisco device. Anybody can beat this ;-)Regards

Harold Ritter · 09-12-2024

Hi @paul mebale , This is a misconfiguration. You need to make sure that the same IP address is not configured on two different neighbors. Regards,

Harold Ritter · 09-05-2024

Hi @MarcSims , The *,G is create by the receivers. The S,G will not be created, as the RP is not configured. As I mentioned in a previous post, the lack of an active RP causes the packets received from the source to simply be dropped and S,G to never...

Harold Ritter · 09-05-2024

You are very welcome @MarcSims and thanks for the feedback

Harold Ritter · 09-04-2024

Hi @MarcSims , > the question was will it work Sparse mode will not work without either a statically or dynamically configured RP. If the RP is not configured the packets received from the directly connected source will simply be dropped and no (S,G)...

Harold Ritter · 09-04-2024

Hi @MarcSims , Yes, configuring sparse mode implies configuring an RP. You can just configure the local L3 switch to be the RP and this will work just fine. Regards,

Member Since	‎05-07-2003 06:18 PM
Date Last Visited	‎09-17-2024 02:33 AM
Posts	8,076
Total Helpful Votes Received	9858

User Statistics

User Activity

Cisco Equipment Record Uptime

Re: mpls_ldp[1240]: %ROUTING-LDP-4-PEER_DUP_ADDRS : VRF 'default' (0x6

Re: Can PIM-SM operate on a single L3 Switch without a PIM RP

Re: Can PIM-SM operate on a single L3 Switch without a PIM RP

Re: Can PIM-SM operate on a single L3 Switch without a PIM RP

Re: Can PIM-SM operate on a single L3 Switch without a PIM RP