Hi,
does anybody knows what exactly is the nature of the RS232 console port with USB type connector on ASR 920 router ?
What is the pinning of this USB connector ?
Is the original USB-to-RJ45 active or passive cable ?
Do I need original cable or can ...
Hi,for MACsec to be operational the two switches needs to be interconnected directly, as far as I know.Does MACsec works over Ethernet-over-SDH links ? Are there any limitations ?Thanks for any information,regardsMetod.
Hi,I have a testing scenario that seems no to work and I don't find eny clue.On switch 3800-B I have configured this two ports. To the port 0/8 I have connected a host with IP address and MAC f0f7.55cf.6201.interface GigabitEthernet0/8switchport acc...
Hi,I wonder how to change the universal IOS version on a router 881 from -npe ( no payload encryption ) type to standard ( payload encryption ) type ?I have tried with Cisco licencing team without success. We have no restriction regarding encriptio...
Test bed configuration consists of Catalyst 6500 and 4255 IDS vith SW version 6.0. The traffic is captured using VLAN capture feature and send to the sensing interface Gi0/0 on IDS. The reset interface is Gi0/3, connected back to the Cat6K. Vlan 140 ...
Hi Waris,the whole configuration consists of some other links and connections, so I might have had a loop somewhere. I completelly changed the design and it works.Thank you for your engagement and best regards.Metod
Hi,It is quite some time when I was dealing with this problem, so my answer is not really accurate.I think you can add an additional class/class-map definition into existing policy-map without a problem.As far as I remember you can put more policy m...
Hi,below is the instruction message that TAC usually sent.RegardsMetodLICENSE KEY INSTALLATION INSTRUCTIONSAttached to this email you will find a file with the ".lic" extension. This is the file that will activate the IOS Feature Set that you purchas...
Hi,I have filtered ot the hosts with ACL. Here is the part of the config.----------------------------------access-list ORADB line 8 extended permit tcp any parameter-map type connection TIMEOUT set timeout inactivity 43200class-map match-all APP_TO...
Thank you for ideas.In fact, any traffic to that host except specific application is not permited.Just IP and port would not suffice, because the reset would contain both parameters.We mada a workaround applying port ACL on the switch where IDS reset...