Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are trying to get this working with 2.6 and Anyconnect 4.7 but lack the information to get this rolling. What conditions needs I to check? Is this only MDM:DeviceRegisterStatus Equals Registered and is this then automatically using the UDI instead...
We have 8 offices connected with leased lines. Each router (3640 with 10baseT ethernet mod, IOS 12.2.7) is connected to a 3com switch with full-duplex. This configuration is maintained at all offices. I encounter severe communication problems with ne...
It's while back since last response here but this issue as well.We have a hub in Amsterdam with internet breakout plus internal DNS servers which have forwarders to resolve public DNS.Now we have a site in Santa Cruz, when they want to use internal s...
2.6 feature: Identify managed devices with dynamic MAC address using UDI We are trying to get this working with 2.6 and Anyconnect 4.7 but lack the information to get this rolling. What conditions needs I to check? Is this only MDM:DeviceRegisterStat...
Today "upgraded" our switch (N5k-C5596UP) to from 5.1(2)N1 to 7.0(5) and after reboot no life from the switch either. Even no console response. show sprom sup | inc H/W shows 1:0.Only thing we could do is RMA the switch. So what must I do with these ...
Hi Dave,You dont need to tell the router about your ip address. I just cross checked it in a setup with 4 routers in a chain(R1--R2--R3--R4)Look at this sample config:R2 (internet router):interface Loopback0 ip address 10.1.2.2 255.255.255.0!interfa...
Hi Steve,Reading your post I assume that your public ip range is not being published. First thing you have to make sure is that your ISP is advertising your pa space, and pointing it to your router with a static route. Or do it your self using bgp.On...
