Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This has been an over two month long issue. Initially there was a power outage and the 9407 was impacted. After power came back up, the second supervisor showed a fault...it showed in a disabled state (sho redundancy and sho module). We eventually...
Is there a tool available for making these transitions less time consuming?Will a cut and paste of configs (with some image/system specific manual changes)?Will we have to reconfigure everything from scratch?
We have a multi-tunnel path in our network from Hub to spoke. We can ping from hub access switch to the spoke access switch. The spoke access switch can ping the CUCM and DHCP server. Before deploying the phone, VTC and workstations, I configured ...
Hello everyone! Thank you for all of the support you guys provide! I am testing a theory. I have two L2 switches (2960s) connected via a trunks on ports 23 and 24. Both connections are by microwave radios. Port 24 trunk is a redundant link in case...
Hi Nithin,Today I added a new phone to CM at hub and headed directly to the spoke. I plugged it in and began it's process. It received its respective DHCP IP address, 150 option, DNS and TFTP address. However the screen stays on "Phone is register...
