Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My team is trying to secure access to our Cisco Firepowers running ASA version 9.13(1) and ASDM version 7.13(1). Currently we have local admins that can login to asdm using username and password, as well as username and password for SSH.I have been t...
I am having trouble connecting interfaces in a port channel from Asa to the port channel in a switch. Is it possible to have a port channel on a ASA connect to interfaces on a switch that are not part of a port channel ?
I am trying to enable active/standby failover which I have done on another pair of Cisco ASAs. But when I attempt to configure it on this specific pair I get the following output. %ASA-1-105002: (Primary) Enabling failover.Mate's operating mode (appl...
Hello, I am running Cisco IOS XE Software [Fuji], Version 16.09.03, I am trying to configure HSRP for failover purposes but the "standby" command is nowhere to be found when configuring my vlan, or my interfaces. When i type "standby ?" i get "unrec...
I have a network that needs two cisco catalyst switches for HA requirements. The way I want the switches to operate are the way the Cisco ASAs work in active/standby. When one switch fails I want all traffic to pass through the "standby" switch. I am...
So i was informed that by using HSRP or VRRP I would be implementing a layer 3 solution. I need to implement a failover solution at layer 2. We currently have active/standby ASAs on both sides of the switches. I want those switches to work in the sam...
I keep getting "Unrecognized Command" when I try to use the standby command while configuring my vlan. Is there other configuration that has to take place in order to enable this command on my switch?
