Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi.CAD don't start after upgrade cucm from 8.5 to 8.6. CAD work well before upgrade. After, when agents ccx start CAD they see warning window:“Login failed due to a configuration error. Please ask your system administrator to associate your phone wi...
HiI have a problem with access from vpn client to inside private network across asa 5510.I have asa 5510 with 8.2 boot loaded bin. I make classic configuration nat exemption for vpn server, but vpn client can’t ping and doesn’t see local file share.C...
HiI had the same problem with windows jabber phonesMy MRA worked but Phone Services were not connected.I had warning message "SIP trunk disallows REGISTER" on Expressway C logI found mistake, it was sip trunk beetwen CUCM and Expresway C, because it ...
Hello Martin
Cisco official datasheet say that sx20 with 12x optical zoom support daisy chain
http://www.cisco.com/c/en/us/products/collateral/collaboration-endpoints/telepresence-sx20-quick-set/data_sheet_c78-688342.html
Table 2
Can you tell, how i ...
I had similar problem with AP1852 8.2.110 & vWLC 8.3"Cert Verification FAILED with error 20 (unable to get local issuer certificate) at 0 depth"I reinstaled AIR-AP1830-K9-8.2.110.0.tar on AP1852 as ME WLC, then I translated it into capwap operationTh...
HiI had similar problem too with call recI found some articles on cisco site that describe possible reason and error:http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cust_contact/contact_center/mediasense/11/Developer_Guide/CUMS_BK_ms-dev-guide-11/...
