Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello guys,short technical question! Setup:one loadbalancer, one physical router, 4 ISP connections (4 dialer)In some cases i want to use a specific dialer in other cases i want to loadbalance (round-robin/least connection.. not sure yet) connections...
Hey guys,could someone provide me (not sure if it`s even possible with tcl) a script which changes the hostname of a device from upper case to lower case letters?The hostname always consits of 5 letters and 3 numbers. e.g ABCDE012And the script shoul...
Hello guys,can someone help me out with a TCL script for some 2960-CG Switches?I need to change the IP Address of an interface vlan in the third octet for about …. uhm … many switches and they are not at my location so I don’t have console access C...
Hello guys, is it possible to get the BIA (the switch MAC) of every switch connected(cdp enabled) to the switch from where i run a tcl script and save this data into a file? And in addition is it maybe also possible to have this file (where i want to...
Hello,recently a Win 7 user had several connection problems. The PC was connected to an 2940.I checked the Switch and got Ping timeouts at different time intervals (from every 2nd packet untill every 20th packet).The problem is recoverable and happen...
Hii am trying to configure this script on a Cisco C6880-X-LE runningCisco IOS Software, c6880x Software (c6880x-IPSERVICESK9_NPE-M), Version 15.1(2)SY5, RELEASE SOFTWARE (fc7)but i can't find the neighbor-discovery event! Is this softwareversion not ...
Why does it not work? SWITCHNAME#tclshSWITCHNAME(tcl)#set hostname [string tolower $hostname]can't read "hostname": no such variableSWITCHNAME(tcl)#ios_config "hostname $hostname"can't read "hostname": no such variableSWITCHNAME(tcl)#tclquitSWITCHN...
Hi Joseph,thank you for the quick response!Do i have to run this as a event manager applet or how can i execute it? My Environment:Hardware: WS-C2960CG-8TC-LSoftware: C2960c405ex-UNIVERSALK9-M 15.2(2)E
