Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
i m newbie in voice and our cucm is giving this error , so can someone advice me what i should do ?
"The system is operating with an insufficient number of licenses. If additional licenses to cover the shortage are not configured in your Cisco ...
Hi ,
we have new implementation for CUCM and cisco ip telephony project
and the integrator recommend to use sip for ip telephony
but now I m reading about some limitation for using sip over sccp , but that in old threads cause I m not expert in ip ...
helloi have a netgear ap and aironet 1140 autonmousand i wanna connect an ipcam by ethernet to one of them i found that i could use universal workgroup bridge feature to achieve that 1-do i have to make the netgear AP as a bridge or i make it as ordi...
i have a cisco 2901 wiz 2 wic ADSL modem , one of them is working fine and the other have problem from time to timethe problem is that suddenly i find that the atm interface is down and the dilaer interface is up and nothing fix this problem until a...
Hello i have two DSL lines and i m configured route map NAT-TO-101 to specify address which use Line 1 and route map NAT-TO-102 to use line 2 and everything is working fine .but now i want to configure failover for both lines so i suggest to d...
i cant find a source tells me that is compatible with my router , so r u sure about this ?and how can i load it ?just i copy it on the flash and reboot the router or i have to do something else ?
so u r telling me that is the same firmware for my hwic-adsl module ?i will try to get it and see what i can do ..but the problem is this 2901 have 2 adsl wicone is working great and the other facing problem even when i try to upgrade the speed of t...
