Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Community,
Continuing with the previous discussion - https://community.cisco.com/t5/wireless/specific-channels-per-wlan-basis-on-cisco-9800/td-p/4838320
I'm using Cisco 9800-40-K9 WLC and C9115AXI-E APs. I have a requirement where the wifi client ...
Hi,
I'm using Cisco 9800-40 WLC.
I have a requirement where I want a specific SSID (say SSID_A) to broadcast on 5GHz on only some specific channels and not on all channel.
That is because the devices connecting to that SSID_A supports only 5GHz and a...
Hi,
I need to disable redundancy on the active WLC for some reason. However, when I try to apply the config after disabling the redundancy, it gives me a warning saying "Clearing the chassis HA configuration will result in both the chassis move into ...
@Leo Laohoo You almost guessed it correct. Not ASCOM but Vocera. I think Spectralink is a product of Vocera
Funny part is, these Vocera badges do support dual band wifi and on all channels, but for some reason (not known to me) the Vocera admins ha...
I have a 3850 switch with an identical issue. I have been unable to get the device to boot using the existing config .I have the following output in 'sh ver'Configuration register is 0x142 (will be 0x102 at next reload)BUT the device does not reload...
