Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm working on migrating our 3802i from a 5508 to 9800-CL. The joining of APs to the 9800-CL is working but I'm not able to rollback to the 5508 running 8.5.182.7, which I am practicing in case there is a need. When I point the 3802i back to the o...
I have the CUBE (ISR4321) connected to a hosted SBC via a SIP trunk. I use this to route calls between the on-prem CUCM and Teams. Can I register an on-prem SIP device, such as an intercom or ip speaker to the CUBE and allow the traffic to continue o...
Hi,Looking to upgrade our CUCM from 10.5 to 12.5 or 14, but noticed 6961 and 6941 phones are not supported, but not deprecated yet. We have many of these models deployed and cannot replace them this year, but getting lots of pressure to upgrade CUCM ...
Hi,I'm migrating from PRI to SIP trunk with new ITSP. I created new dial-peers and a test call from an inside phone to mobile number isn't using the expected dial peer 300 between CUCM and CUBE. Instead it's using an existing dial-peer 2. I'm not sur...
Hi,We have a new sip service but have not ported our numbers to the new provider yet. Surprisingly, it seems possible to make an outbound call using the new service with a non-ported number. Do providers allow calls from numbers that don't belong to ...
Thanks. I ran the image swap command via the console to the AP instead, because I already had the connection. I ran a 'show version' and the Backup Boot Image showed '8.5.182.7'. I configured the AP with 'configure boot path 2' , set the primary-base...
Thanks for the clarification.We're using the CUCM currently, but it's short term until I have the speakers and intercoms connected to the Teams SIP Gateway. The directive is to not refresh the CUCM hardware or renew the support.
That is a good reply, but I was hoping to hear from anyone using, or tried to use, these models with CUCM 12.5 or 14. Hearing from someone's experience that tried these models would be helpful.
I apologize for confusing the network design. The routing table I referenced is more accurate than my attempt at using text to show the design. I was showing how OSPF and the trunk were formed between the two switches. Jon is correct and the question...
