How to install CIPC on Virtual Machines
Please make sure you have already installed Virtual Machine on VMWARE, Virtual Box etc.
1) CIPC setup
2) Virtual Audio Cable
Step 1: Open a Remote Desktop session to your Virtual Machine.
Open Local Resource Tab and go to Configure remote audio settings
++ In settings choose Play on this Computer and Record from this computer
For Windows XP: choose "Leave at remote computer";
For Windows 7: Settings => Play on remote computer.
Step 2: Installing Virtual Audio Cable:
++ Extract the Virtual Audio Cable
++ Run the setup.exe depending on your system (32-bit and 64-bit both are included in this .rar file)
++ Once the installation is successful. Go to Device Manager and check if it has installed correct
Step 3: Installing CIPC:
+ Extract the CIPC file that you downloaded You can use your version of CIPC if required.
+ After that reboot the system.
Step 4: Running CIPC:
In Windows 7 CIPC should be run in compatibility mode to be able to use virtual audio cable : Right click on CIPC shortcut => Properties => Compatibility tab => Check "Run this program in compatibility mode for:" => Windows XP (Service Pack 3)
So before running the CIPC please make the compatibility to Windows XP (SP3) and run as administrator.
Find attached document
... View more
This is how I resolved it + Restarted the below services : Cisco Desktop Sync Service Cisco License and resource monitor Cisco Desktop Enterprise Service Cisco Desktop LDAP Monitor Service + Again performed manual re-sync , however we had no result + We found that RMCM subsystem was in initializing state. + Changed the password of RMCM and service came up + Issue was resolved
... View more