Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I keep getting wrong provisioning mode whenever I try to add the EQX endpoint to TMS v15.13.7all provisioning details on the device appear to be correct but still no candy.Can anyone else assist as to why this is the case? Before anyone chimes in say...
As my title suggests, with TMS going out the door, rather than focus on palming an on-premise meeting scheduler to some other vendor, why not just scale up Cisco Meeting Management? The latest version 3.9 is pretty snazzy and works well intertwined w...
Evening all, whenever I create an adhoc meeting with x amount of endpoints, meeting management (v3.7) identifies the meeting with a 16 digit dial string which is the sip uri anyone else can dial directly into.I can't for the life of me see where this...
I have recently migrated from non-secure mode to mixed-mode in CUCM v12.5 with little issue. For each device, after installing the CAPF feature, it defaults to 'no installation pending'.Now my NOC staff are asking how to copy or supercopy the Install...
The message in the title does not disappear (appears only in the PCisco Bug Discussions, Cisco Bugsublisher) after upgrading my entire cluster.Only until I ran a post upgrade check on the Publisher and then a reboot made that disappear.Why do these m...
Hi @Roger Kallberg, its about feeling comfortable with deployment and I suppose also not having to worry about constantly updating it every so often unless absolutely necessary. Can I ask if you've come across any issues since going to 15?
Hi @Siva chinap, how did you go with your upgrade? I recently did a direct upgrade from 12.5--->14 and found it fairly straight forward. I will wait for v15SU3 to arrive before deciding to upgrade again via the same method..
Did Cisco not consider their on-premise customers when deciding to go this route?Either way, is there another option other than getting a 3rd party tool to mass deploy macros to my entire video endpoint fleet? Thanks.
Hi Geeta,Thanks for your solution, I have faced the issue where the DB shows disconnected. I have performed the steps as mentioned, uncluster, upgrade version by version, then recluster at the end. Out of the 5 servers, only one shows as disconnected...
