Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good morning everyone!I've been tasked with figuring out a potential design utilizing Cisco FTD devices. Currently, there are a small handful of firewalls set up with crypto maps to a hub site. We are going to introduce two more sites into this. One ...
Hello all, I was wondering if it's possible to put a CSR1000v in Azure and connect it to an existing on-prem DMVPN set up? Any documentation I find shows the use of a transit DMVPN cloud in between various vNETs and the on-prem solution. We will only...
Hello all, I have configured multicast and an Informacast paging server in my lab.I'm using a 3560 switch as a core, a 2911 as a VPN hub, a 2911 as a remote site VPN spoke, and a 2960s as the switch for that remote site. Configured in a DMVPN multip...
Hello all, We are looking at options of cordless phones. We are aware of the 8821 and would rather not have a 802.11 wireless phone. Has anyone used the IP DECT 210/6825 in their CUCM environment?The other option we have is using an ATA191 and an an...
Hello all, Looking through the Admin and Install guides for DNAC, I see that HA clustering is available, but only if the 3 nodes are in the same subnets and are in the same data center. How does on achieve multi site redundancy for DNAC? Is it just...
Thank you so much!Any advise on the routing protocol choices if I was to go with a full route based mesh? At this point I have these options, right?Use IBGP company wide, all core switches and firewalls have the same ASUse IBGP for the firewalls and ...
That check box doesn't do what you're wanting it to do, unfortunately. It looks like it limits the amount of hunts to one step per device in the hunt list, rather than using busy trigger of the line on the devices in the hunt list. I honestly can't s...
When running a "show ip mroute" I see the route all the way on the far end. Incoming interface as Null, and outgoing interface as my phone vlan sub interface. On the core switch I see the incoming interface as Null and the outgoing as a test vlan wit...
Hello Meheretab, Thank you again for taking the time and responding. I've sent you my sanitized configs in a private message because you're the only one who showed any interest. Thanks, Chris
