Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Team,
I have a customer deployment that is using Windows clients with machine only authentication. A certificate is downloaded via GPO whilst in monitor mode of ISE.
When I transition to low-impact mode, everything works fine except where the ...
We are in the test phase for a deployment and are trying to get Q in VNI working overa VXLAN fabric . When sending untagged traffic to the dotq tunnel interfaces we get connectivity between the hosts,.When sending a802.1q tagged frame, the Leaf switc...
Hi,Anybody know if its possible on a WLC to block a specific MAC address per WLAN. I know you can do this globally with "Disabled Clinets". I also know you can use MAC Filtering. But I need to deny a specic list of MAC addreses and allow all others. ...
Hi All,I am planning on buying a third party cert to install on a WLC. My question is, does the "Common Name" that I include on the request for the certificate need to be an actual public domain? This is just for a guest scenario and I dont want to u...
Hi Guys,I need some help with QoS with this scenario. Take a look at the attached.There are 3 sites connected with 100Mbps LES circuits with a 3560 on each site.I have configured STP priority to load share some of the traffic.Vlan 100 is going to be...
Hi Greg
Thanks for your reply. I had already reviewed your post previously and found it very helpful. In this case we are adding the MAC for the build process. So we would be good up to the point of GPO push when the PC receives the supplicant config...
Thanks for the reply @ahollifield. I have considered option one and option two, both of them cause issues for the customer, but may have to be used if I can't find a better solution. Do you have more info on option 3 please? I need ideally for this ...
I seem to have gotten to the bottom of the issue. It is configured correctly, however the following line from the latest release notes is incorrect, and the feature is not yet supported and will be supported on the EX line in Q4.
Thanks for your help...
