Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiRunning latest 6.0(2)N2(1) code on my 5548s. I would like to source all outgoing ssh sessions from the switch loopback0 interface.The cli has "ip telnet source-interface" but no "ip ssh source-interface"Is this a bug/oversight?Thanks.
Hi,If possible I would like to see a UDLD neighbor between my 5548 Nexus swtiches and my 6248 Fabric Interconnects.UDLD feature is supported on the 5548s and easily enabled.However I can't find any information on how to enable it on the UCS FI ethern...
HiTotal n00b on EEM here. Background - we have an inline transparent L2 firewall sitting between our Nexus core switch and our UCS. If the physical interfaces on one of the firewalls go down, our UCS virtual hosts can detect that and will automatical...
Hi,I have an ASR 1001 router running latest 3.9.2S code.The udld feature was introduced in 3.9SHowever..With the IPBase license the udld command does not appear in configuration mode.But when I enable the AdvancedIPServices evaluation license and reb...
Hi I have a pair of Nexus 7000s acting as distribution switches for 52 access layer stacks of 3750x's. Southbound there are 52 Layer 2 VPCs into each N7K. The N7Ks are a HSRP pair providing L3 gateway functionality for all devices connected to the ac...
HiI found this in the configuration guide for the Nexus 7000 configuring VPCs"When you enable this feature (peer-gateway), Cisco NX-OS automatically disables IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirec...
Ok thanks, dont want to waste any time on it if its not going to work. If it doesnt look at cli output then I would probably need the neighbor discovery cdp stuff thats not available in NX-OS. Looks like UDLD feature will be available in the next ver...
I'm running the latest 6.0(2)N2(1) NX-OS on the 5548 with the Layer 3 daughtercard and LAN Enterprise Services license. There is some EEM stuff in the CLI but it appears basic compared to what is in IOS.NEXUS-SW1(config-applet)# event ? cli ...
I'm running an SNMP access list and also have the default COPP strict priority, pretty surprised anything external could push the CPU to 100% with the strict COPP policy applied..
