Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
We need to Integrate between DNAC and ISE in Assurance deployment "Not SDA" so in that case the ISE will be configured on DNAC in Authentication and Policy Servers.
In the assurance mode The ISE should be added as ISE or AAA Server?
Hello,
We have Cisco spaces with a connector setup, after 3 month from the implementation we found the DNA Spaces connector token is expired. We can regenerate it but is it normal to generate the token every 3 month?
Hello,
We need to configure ERSPAN on cisco 3850 and 3650 Switches
The source ERSPAN will be C3850: with the below configurationmonitor session 11 type erspan-sourcesource vlan 2140 - 2141destinationerspan-id 100mtu 1500ip address 10.137.200.1 "C3...
Hello,
I'm trying to integrate between DNA Center and Cisco Spaces, after copying the token from cisco spaces and try to paste it on DNA Center the below error message appear on DNA Center
failed to validate Cisco Spaces Certificate, Please check the...
Many thanks all for participating in this valuable discussion, if we will add it on DNAC as ISE, regarding the ISE username should be the default admin username or it can be any account with admin privilege? @Preston Chilcote @Ambuj M @Flavio Miranda...
The below is output from "show diagnostic result module", Kindly notice that the current SW version 6.2(20a)
Module 2: 1/10 Gbps Ethernet Module
Diagnostic level at card bootup: complete
Test results: (. = Pass, F = Fail, I = Incomplete,U = Untested,...
i found the below logs regarding the line card:
Module Slot Number: 2Device Id : 168Device Name : Clipper FWDDevice Errorcode : 0x41830059Device ID : 24 (0x18)Device Instance : 48 (0x30)Dev Type (HW/SW) : 00 (0x00)ErrNum (devInfo) : 89 (0x59)System E...
