Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Community, I'm trying to setup NAT for the following scenario with no success so far. I need machine 10.5.2.33 to communicate with 189.23.0.85 and vice versa.Only RT1 "knows" how to reach both sides. I almost managed to have this working with the...
Hi,
The Scenario
I am deploying a Unified Communications solution based on a Cisco BE6000 environment (which comes in a UCS C220-M4 with pre configured voice applications).
Of all those voice applications within the bundle I am only using CUCM, CUC...
Hi,I'm trying to upgrade a CUCM running version 10.0.0.97026-19 into version 10.5.1.10000-7 but, apparently, it's not possible.Searching for info on this release produces almost no results. So, after trying to upgrade to 10.0(1) SU1 and 10.0(1) SU2, ...
Hi,A client has 2x2811 acting as Voice Gateway and backup Voice Gateway and both, after some undisclosed circumstances, are not booting.After some troubleshooting a faulty memory DIMM was detected on the primary Voice Gateway. Still, DIMM replaced, i...
Hi,Cluster (1 PUB + 4 SUBs) running on VM with version 8.6.2.20000-2 VMware Installation: 2 vCPU Intel(R) Xeon(R) CPU E5-2643 0 @ 3.30GHz, disk 1: 80Gbytes, disk 2: 80Gbytes, 6144Mbytes RAMWhen trying to perform a manual backup, in the "The followin...
Hi Julio,Here's the output from both show ip nat translations and debug ip nat. The following outputs are the result of a telnet 189.23.0.85 445 from 10.5.2.33. If i try to telnet to10.17.8.100 445 from the same machine nothing happens. RT1#show ip n...
Hi JulioThank for the prompt reply. It is indeed a typo. It should be:ip nat inside source list NAT_OUT interface FastEthernet0/1 overloadI will collect both outputs and share.Thanks
Hi Ayodeji,
Thanks for your input on that. Already took it into consideration after applying the upgrade patch which, btw, solved my automatic startup problem.
Hi Rajan,
Actually, that's one of the discussions I read previously. The problem is that the recommended patch is for ESXi version 5.0.0
(ESXi 5.0.0 build-623860).
I have version 5.5.0. But still, I'll go ahead and try the latest build for this re...
