Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
good day,i'm reading the BYOD document and found out that the switch and ap's below are the only listed on their designed, does it mean normal 3560's and 11xx AP's series can't support BYOD solution using ISE? could someone confirm please?cat switche...
Hi All,Could someone confirm if the below nexus 5020 nx-os version and type/revision of my GLC-T is compatible with each other? I noticed also the "Transceiver calibation is invalid" when i do show int e1/8 transceiver details , what does it mean?UT...
Hi All,We got requirements from our Emergency group that they need one DID to be use for recieving emergency calls and this DID will be distribute to 6 IP phones. And if all the IP phones are busy or no-answer they want to forward it to one mobile #...
Hi All, I would like to reload my FWSM configured in failover mode, the switch is in VSS mode. Is the command "hw-module module # reset" will reload the two pair FWSM or only the active one? thanks in advance!cheers!reymon
Hi All, I'm in th process of configuring FWSM to relay DHCP request from the client pc/ip phone going to our DHCP server. But the thing is, my client pc/ipphone are not connected directly to FWSM instead i have a L3 switch for the data/voice vlan an...
Have you tried removing the native vlan on below config since the ASA FW doesn't support this feature? interface Dot11Radio0.1 encapsulation dot1Q 1 native!interface GigabitEthernet0.1 encapsulation dot1Q 1 native HTH -Reymon
Hi Steve, Can you do a show ver from your ASA? You should have a "security plus license" in order to configure trunk port on ASA FW. Please rate if this is helpful. HTHReymon
Have you tried connecting the asa trunk port to a cisco switch with a trunk port? I believe your ap connection is directly connected to the firewall. HTHReymon
Hi Evidio,Can you include also the route-map configs:neighbor *hidden* route-map Central-FL-routes-in inneighbor *hidden* route-map Central-FL-routes-out outAlso, from a machine, you can do traceroute to identify where your routes are heading to..HTH...
