Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've got a Cisco C881-K9 router. Older end of life model. Surplus equipment. I had plans to brush up on my IOS config skills. It appears to be stuck in IOS recovery mode by looking at the errors below: boot: cannot determine first executable file nam...
Hi,
We've purchased a new Cisco 8841 phone for evaluation. I've got it up and running on the CM. I've upgraded the phones firmware to 12.1-1 SR1-4. The phone has a sticker on the bottom of it that says SW must be 11.7 or later so I understand it c...
Hello Experts,
I have a question regarding packet loss and Cisco QOS. I am having a packet loss issue. I have a Cisco VOIP system running with no issues. I have a 1Gb fibre link to a remote office across town. We have had this setup for several year...
Hi,
We are in the process of installing a new UCS Mini and having difficulty trying to troubleshoot the attached error message. It appears to be some type of certificate error that needs to be repaired?
Thanks
Hello, We have a CUCMBE 8.6 system. I have a reception station that has a 7965 phone set. It has 5 DN's 1000,1001,1002,1003,1004. They are DID lines for various functions. At the end of the day we forward the phone directly to voicemail CallFWD - env...
Good suggestion! I thought that might have been it. I just push cycled the little button a few times. I can hear the clicking when I depress it so I'm pretty sure now the unit is bricked. Thanks for the suggestion.Shane
Yeah I hate to give up on this also. It was a given to me free but I suspect its bricked. I was hoping to use it to brush up on my IOS skills. It is a nice little fanless unit. Anyhow thanks for your help on this! Shane
I uploaded the CM device update pack to the CM server as per the instructions. I rebooted the phone and it upgraded and now the inactive load id message is gone. Everything looks good! Thank you!
I just updated the firmware for that specific phone. I didn't update the device pack. I didn't want to upgrade the rest of my phones. I have a bunch of 7942,7945 and 7965 phones. I'm guessing I should upgrade the device pack to 10.5.2. on the CM?