Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I set up a VPN I can connect, I can ping between connected host and every Vlan interface on my network on a couple switches and access points but can't ping any hosts connected to switch ports I would like to be able to see and connect to vlan3 hosts...
Hey folks, I've got my VPN setup I can make connections to the VPN, but I can't figure out the last steps required to allow the machines connected to my interface Virtual-Template1 to access my VLAN 3 here is my config as it stands: Using 5367 out o...
Hey folks I have a cisco 1921 router with VPN module installed (my office's old unit). This is a functionality question as in is what I am thinking of implementing is even possible. The structure I would like to implement is: I'm not super versed ...
Hey folks I'm having an issue with my AP's allowing my clients to authenticate to a RADIUS server, I know the sever works because I can get my clients to authenticate when I don't setup VLAN's on the AP's, but once I setup VLAN's they can't seem to r...
Hey folks I have a AIR-LAP1142N-A-K9 in autonomous mode, I have a couple SSID's associated to VLAN's that are working, but in my network I use VLAN 99 to be a management VLAN giving my devices address's to access them, now I'm trying to do the same w...
Well at this point after trying to add a bunch of zone based rules(and ending up in the same boat able to ping gateway but nothing on the inside zone) I can only assume that my virtual-template does play nice with zone-membership as I see no differen...
I did that too with no luck, now the really weird thing is if I have the virtual-template setup as inside zone and remove the inside zone form Gi0/1.1 I can't ping my host until i remove the virtual-template from the inside zone as well. As far as I...
The problem that I'm seeing is that when I'm connected to the VPN I can't ping/connect to my host on Vlan3 unless I remove the zone membership on my Gi0/1.1 interface on this current config: Current configuration : 5535 bytes!! Last configuration cha...
