Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
After an upgrade from DNA Center 2.3.5.4 to Catalyst Center 2.3.7.7, PnP fails for some swiches though works for others during onboarding. Strangely enough, this problem started a few days after the upgrade, pnp was working fine for 2 or 3 days a...
Hi,
I have an intermittent problem where DNA Center seems to error out when provisioning templates to switches, the log says:
Message: Unable to push the invalid CLI to the device 192.0.2.2 using protocol ssh2. Invalid CLI - 'terminal width 0'. C...
We are onboarding switches running ios-xe 17.11 using PnP via dnac and they are not automatically being configured for smart licensing using policy. The default smart license transport setting seems to be cslu, and switches get the default call-home ...
I’m trying to ztp deploy switches via dna center with the variables comming from a database. This is a normal network, not SDA.
1. Is there a way to enable application telemetry on a device via api, ive looked around and cant seem to find anything?
2...
Hi,
I am unable to open the Prime Data Migration Tool from prime 3.10.1. I can open the " Hamburger menu > Prime Data Migration Tool" page. When i click the "Launch Prime Data Migration Tool" button a new window opens with a blue loading bar and "Loa...
Hi @Mark Elsen @Preston Chilcote
Found the source of the aaa config, we found this in the console while it was working through PnP. "%SYS-5-CONFIG_I: Configured from tftp://255.255.255.255/network-confg by console".
So tftp from broadcast downloaded...
No the day0 template doesn't have any aaa commands, and works with most switches, same model, same image from the factory. This problem is showing up in the onboarding process before the day0 template is even called. It also shows up even if the swit...
Hi,
The linked bug id https://bst.cloudapps.cisco.com/bugsearch/bug/CSCwf37179 indicates that its a problem with variables bound to source.
The template that has failed has no variables at all.
Hi Preston,
Thanks for the info, its pointed me in the right direction. I can manually run a "discover" task with netconf selected and the switch will be available to be licensed via the gui workflow after a short time.
Ideally this would be somethin...
