Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 1841 that I want to use to bridge my T1 over to ethernet so I can assign my T1 IP address to the outside interface of my pix.I have the 1841 with an Internal CSU and a crossover cable going from FA0/0 to the Pix outside. I have disabled ip r...
Hello, I am trying to upgrade my call manager server from 4.0(1) to 4.1(2) and it gets halfway through and then asks me for CD2 (which is on the same CD) and it won't take it. The only way I can continue is if I put in CD2 of the 4.0(1). However, thi...
I apologize if this question has been asked already but how do I install Call Manager on a Compaq DL360? I don't have any 380's here and the operating system CD keeps telling me that the hardware is not supported. I've seen them run before on a DL360...
I am trying to connect the VPN client 4.x to an IOS (12.2.8T) router using certificates. I can issue the router the certs and I can see all 4 of them (ra-sig, ra-enc, ca, and general) but when I try to connect using the client I get the following err...
Hello,I am getting a large number of frame input errors on my trunk port. I have a 3548 connected to a 3640. Even ping packets generate errors. I have tried different cables and different ports. The router has 0 errors, they all appear on the switch....
I guess either I am configuring it wrong or misunderstanding bridging. Attached is the config my router has. The IP address that's normally assigned to S0/0/0 I have assigned to the outside of the PIX. (The FA0/1 on the router address is only there f...
Thank you for the reply. I do have ICMP permitted on the pix I actually had it in use on a cable modem before this T1 went in place. I think the problem I have is in the bridging on the router. I see that I am getting RX packets but no TX packets whe...
Thanks Kevin you pointed me in the right direction. The problem was that the FA0/0 was set to half-duplex. I never even look at the main interface itself, I was just concerned that the sub-interfaces were correct. Once I changed it everything started...
Yep, works fine 9600,8,N,1.I've come to believe that I just have a bad Async port. Although if I use the router for dial backup it works fine...go figgure.But to answer your question, using a regular computer in the console port works fine. I've also...
Same problem: Here is my new config. I tried attaching to all 5 of the connected devices.Current configuration:!version 12.0service timestamps debug uptimeservice timestamps log uptimeno service password-encryption!hostname Router!ip subnet-zero!!!in...
