I don't know if this exist but I'm looking for a matrix that shows the feature and hardware/software differences of all Cisco access switches. For example 3560 vs 3560 vs 3750 etc. Something simple that just shows the major differences between the mo...
If I understand it correctly on a switch port that has an IP phone plugged into it the command "switchport priority extend cos 0" would ensure that the PC traffic was set to COS 0. But what if this command was applied to my layer 2 WAN interface? Wou...
1. How are calls transcoded from G711 to G729 in a CCM environment (with remote sites separated by regions) when I do not have any transcoders configured in CallManager? CCM must be transcoding behind the scenes somewhere. Is this a non-configurable ...
Reinstalling CCM 4.1.3 SR3 on new hardwareI know that CCM has to be the same version when doing a BARS restore. Does that include the service release? I have the software needed to get the new server to 4.1.3 but I am unable to find SR3 on CCO. I did...
Thanks for clarifying the PVDM/DSP Farm issue. In the document, I was referring to: "Restrictions for Configuring SIP-to-SIP Connections on an IP-to-IP Gateway" -> "Transcoding is not supported".I now see where it says transcoding is supported under...
Thanks for the replies. I found another link that says that "Transcoding is not supported" on SIP to SIP connections:http://www.cisco.com/en/US/products/sw/voicesw/ps5640/products_configuration_guide_chapter09186a00806b0a14.htmlHowever it is supporte...
Thanks! Another quick question...So now I can add a sub interface such as: "interface serial 0/0/1:1" but why can't I add the serial interface as just "interface serial 0/0/1"? Is adding a sub interface a requirement on this router, with this confige...
