Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, I need some help regarding static NAT configuration.
I have setup the following NAT configuration that is working as expected.
interface GigabitEthernet0/0description OUTSIDEip address xxx.xxx.xxx.190 255.255.255.192ip access-group BLOCK_P...
Hello all,
I'm looking for a solution to filtering specific routes being advertised from an adjacent neighbour but no filtered from other routers via EIGRP.
I have tried the following configuration, but this blocks all updates from all routers for t...
Hello Guys,I looking for some clarity on AAA Authentication configuration.Problem StatementUsing the configuration below, when i logon with a user account that is valid in the RADIUS server i am able to successfully SSH to the switch, if however i tr...
Hi GuysI have a situation where I need to prevent EIGRP routing updates being received by my local network routers from an other router that I have no control over, however I still want to receive updates of all the external routes from this other ro...
As the subject heading says I am experiencing extremely high CPU utilization by the EXEC process.CPU utilization for five seconds: 97%/0%; one minute: 96%; five minutes: 96% 2 ME 80335584 8180376 129506 6316610968/12000 65 Exec 129 M* ...
@Rasika Nayanajith Thank you for posting the link to the configuration guide. I have an addition question that i have not been able to find the answer to so far. In the guide you posted it shows the WLC being NATted to a controller on the inside of t...
I want only one public IP address to access the internal statically NATed address.I have tried creating an access list and applying it to the g0/0 interface inbound but it seems to stop all return traffic from the 172.19.128.0 0.0.3.255 network.
