Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have two IP's Configured on my Cisco 2800. 1.1.1.1 - Loopback and 2.2.2.2 on Fast Ethernet. Both IP's are pingable across the WAN. And telnet to loopback IP is working fine. However I am unable to telnet to Fast Ethernet IP. The error message w...
Posted by: vatsey.sharad - Engineer, HCL Comnet Jun 6, 2008, 2:09am PSTHi, I have two IP's Configured on my Cisco 2800. 1.1.1.1 - Loopback and 2.2.2.2 on Fast Ethernet. Both IP's are pingable across the WAN. And telnet to loopback IP is working fine....
Hi,I have two IP's Configured on my Cisco 2800. 1.1.1.1 - Loopback and 2.2.2.2 on Fast Ethernet. Both IP's are pingable across the WAN. And telnet to loopback IP is working fine. However I am unable to telnet to Fast Ethernet IP. The error message wh...
Hi,This is one of the interesting issue which i am facing. Whenever my client tries to send a file less than 1kb, the file is transmitted successfully over ftp, but for files greater than 1kb, the files are not being transferred, instead a 0 kb file ...
That is to divert traffic from and to specific subnets to the second WAN Link. However even when i gave a :Permit IP any any" in Route Map's ACL, the telnet session was not established.
Hi, Many thanks for the reply.I need two VLAN's and configure Inter VLAN Routing. I do not want to configure encapsulation on my subinterfaces. If i enable encapsulation on my Physical Interface, i guess the child (logical) Interfaces will automatica...
