Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears
I have a voice gateway problem.
We have a voice gateway connect to PBX using FXS port, and the phone is connected to the PBX.
The voice gateway have two SIP trunk to CUCM Pub & Sub, and there is a MGCP gateway that managed by the CUCM.
The MGCP...
Hello everyone, We have some question about the DNA Center API.We know that we can use the API to connect to DNA Center and get some information that you need, or change some configuration.We also know that we need to get the credential to authentica...
Dear all
We try to install a new DNA Center
When we boot the server
It says that missing or unsupported RAID controller memory detected
as the picture I captured
But when I login the CIMC to check RAID CARD and virtual drive
It seems good
If I fo...
I have two Nexus 7000And both two connect to a IPSI want to connect two Nexus 7000 to the IPS using vPCAnd configure the vPC as a SPAN destinationdoes it work?thanks
Dear All,
I am deploying a Jabber enviroment
But I faced to some issue of registering Jabber to CUCM
First I found that Jabber for android can registered to my CUCM
But MRA can work find.
That is, Jabber for Android can register to CUCM through vcs-c...
Because We also think maybe is the PBX problem, so we try to direct connect the phone to the voice gateway FXS port and bypass the PBX.
But we still have problem, so we think maybe is not the PBX problem
Dear Maren
Thanks for you reply.
But in my unstanding, the voice gateway is sip gateway, and in the voice port, I config the timeout interdigit for 3 second.
I think the router should wait for 3 second after the user dial all the number, and then sen...
Hello Reza Sharifi,I will try it but I still want to know if it can set a vPC as a destinationCould it work fine?Maybe it is different by moduleI saw a document that says Nexus 5000 can not configure port-channel as a SPAN destination portBut in this...
Hello Reza Sharifi, But in the document,It says that 'Destination for a SPAN session include Ethernet ports or port-channel interfacesSo It means I can set the port-channel to be destination,right?
