Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I need to create a vpc and I would like to ask if I need to configure vlans both on the port-channel interface and the physical interfaces too. Thank you in advance. John.
Hello, I have a question regarding interfaces connecting a server with FEX, managed on Nexus 5596UP. The question is: can you bind an interface with a vfc interface, used for storage traffic, and forward lan traffic too? Can you also monitor traffic ...
Hello,
I am working on a data center environment in which we have a SAN network consisted of two MDS9506 and two MDS9250i switches.
We want to monitor the network and collect data because we have seen slow data transfers between end nodes.
I h...
Hello,
We have a SAN network that is made of MDS switches (9506 and 9250i) that seems to perform very inadequate with the speed of cards and cabling (8G).
We don't have a monitoring tool, like netflow, for the purpose of monitoring SAN/LAN traffic ...
Hello,
Thanks for your reply.
Yes, I am aware about this document and I am reading it in order to have a closer approach about this subject.
More than that, do we have to purchase a license on DCNM (10.2(1)) to use slow drain analysis feature ...
Hi Mark,
We have a couple of FEX2224 just for mgmt traffic in a vpc configuration with 2 Nexus 5596 but there is a need to use a port from one of these mgmt FEX just to allow traffic for a data vlan.
This port will be an orphan port.
Will the vpc...
Hi Joseph,
So there is vlan isolation in any case as is for vlan hopping if the port is not consider as trunk and not configured to participate in DTP.
Am I right?
Thanks in advance.
Best Regards
John
