Is there a wireless Cisco IP Phone that works with CUCM 12.5 and is able to establish a connection via VPN remotely?I was researching and found the Cisco CP-8821 but I can't find any information regarding VPN.Thank you
I need assistance on how to properly stack these 2 switches together. Both switches were reset to factory settings and upgraded the firmware to the latest version available. I have tried but have failed to get them to work as 1. Here's what I have do...
Hello, We have 2 SG500x switches which are stacked together via SFP cables and we would like to add an SG500. Is this doable? If so, what changes do I need to make? Please advise. I have tried several things but have been unsuccessful. Thank you
Hi, I have a Cisco N3K C3048 switch that is currently running in place and would like to export its configuration and imported into another (same model) C3048 to have it as a backup. Is there a special way to do this? I normally use TFTPd64 and putty...
I have a set of 3560G switches and would like to configure all the ports to access VLAN1 and VLAN100. Is this possible? If so, can you provide me instructions or guidance on how I can accomplish this? I'm currently accessing the switch via Cisco Netw...
Sorry for the late reply. I have successfully configured 3 SG500x switches and is working as intended. I configured one with an IP address and the other 2 copied the configuration. Unfortunately, I still can't get the SG500 to work with this stack. I...
Got it!!. What if I want to make changes to a port on the slave switch? How can I log into that switch web portal and make the desired changes, since the only way to do this is by its IP address? Thank you
Thanks for the reply.Does this need to be configured on all the switches? Also In the initial setup I configure each switch with their own IP address, but I noticed that when they are stacked I can only ping the master's IP address. Is this a normal ...
I believe I figured it out. This is what I did; NexusSwitch# conf tNexusSwitch(config)# vrf context managementip route 0.0.0.0/0 192.168.5.1NexusSwitch(config-vrf)# copy running-config tftp:Enter destination filename: [NexusSwitch-running-config]Ente...
Thanks,I made the changes and per the link you provide me. I used this command;copy tftp://192.168.5.155/configbu.cfg running-config > pressed enterI received this message after pressing enter in the above command " Enter vrf (if no input, current vr...
