Below is the switch diagram. As you can see, sw01 is directly connected to SW02 and sw02 is also connected to SW03.SW01 <-----> SW02 <----> SW03Each switch has three VLAN's.SW01: VLAN1: 10.10.1.1 , VLAN2:10.10.2.1 and VLAN3: 10.10.3.1SW02: VLAN1: 10....

I want to apply the QoS service on the ATM interface, but fail.Router#interface ATM0/1/0 bandwidth 2048 no ip address scrambling-payload atm vc-per-vp 1024 no atm auto-configuration no atm ilmi-keepalive no atm address-registration no atm ilmi-enable...

I use ACS ver 4.2, and set up the following configuration on the routers.aaa new-modelaaa authentication login default group tacacs+ localaaa authentication login no_auth local enableaaa authorization config-commandsaaa authorization commands 1 defau...

We have a Corp network (VLAN) and guest network (VLAN) setup on the switch 6509E. We are looking for any solutions (restriction) to make the computers in guest network to prevent accessing to any computers in the Corp network and any computers in the...

We have two ACS servers. Our goal is to make one ACS to setup as primary and the second one as standby on the routers & switches, so when the primary is down, we can login the equipment via the secondary ACS without any issues. But it seems it doesn'...