Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two 2950 switches linked to a 4506 switch which is onward linked to a router. The two 2950s both support two seperate subnets.I don't want to implement VLANs (for reasons I won't go into here) but I do want the switch to pass packets between ...
Does the 4006 with Supervisor II+ natively support Layer3 switcing? If so, can it also handle access lists?Likewise with a 4506/Supervisor II combo?CheersDuncan
Hi,I'm struggling to come up with a workable solution for VLANs within a messy network.There's currently 3 subnets (effective class Cs), no VLANs, roughly 350 hosts, spread over some low end switches which in turn link to a pair of 4506s (Supervisor ...
I'm planning a design that will need two 2950s to support 4 vlans. Non-local traffic will be routed out via one of two HSRP routers (one pair of vlans using router 1 as a primary, the other pair using router 2).I've dug around the cisco documentatio...
depends if you're using vlans on the ap or not (if yes configure qos on the ap, if no configure them on the switch.the following is a useful resource on wireless qos...http://www.cisco.com/en/US/customer/products/ps6441/products_configuration_guide_c...
Thanks guys. For future reference, the software version is showing up in a 'show ver' as 'WS-C4506 Software, Version NmpSW: 7.6(6)'Is this CatOS? I'm used to router IOS so am a little lost with the meaning here. What is 7.6 referring to and is it ...
