Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi, can anyone tell me if a pseudo wire failure will generate a trap? Sorry but I don't have the facility to test this myself. This is specifically for Ethernet over MPLS is port mode.Thanksmark
CCO Link;http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a00804a4097.htmlhi, CCO documentation for this technology states that when configuring MLP over FR, FRTS and policy-maps must be configured. The examples sho...
Hi, I have a number of routers that are constantly creating failed authentication attempts in our ACS logs. Sometime the username is a part of the router banner or a part of a console message that is in the log file. We have secured CON and AUX ports...
Hi, I'm no expert when it comes to MSDP but did study it for CCIE. From memory you can use BGP or IGP for RPF check. When using Anycast you would normally use IGP for RPF as the loopback address (which is the same IP address on 2 routers) is advertis...
I have done this before on ACS. You need to do the following;setup a "Shell Command Authorization Set" which is under shared components. You will need to add the commands you want to permit then select the "deny unmatched arguments" box. When this is...
Hi, So the config you have posted is for your 7206 and you want to transfer this to your 6509? I'm also assuming that the main interface on 7206 GE0/1 is a trunk interfaceI dounbt you'll be able to setup subinterfaces on the 6509. You should really s...
Hi, bit of a longshot really but sometime ago I configured IPSec with CA Server. This required RSA keys on the router and one thing I remember was that the router clock had to be set correctly or the RSA key would not be active. Can you confirm the c...
