I have been tasked to setup a bunch of remotes sites to a different AAA/TACACS server.
Can I run the old settings and the new settings on a router without any conflicts?
What issues could I run into?
I have a ws-c2960-24tc (12.2(35))and a WS-C2960-24TTc (12.2(25)).I was trying to power 3 wireless access points AP 1242's though them. I found a Cisco document that stated that you could only run a limited number of power injectors through this switc...
I have a ws-c2960-24tc (12.2(35))and a WS-C2960-24TTc (12.2(25)).I was trying to power 3 wireless access points AP 1242's though them. I found a Cisco document that stated that you could only run a limited number of power injectors through this switc...
I am looking for the IOS command that shows what users laptops are using a 1240. On the web interface under asscoiation tab it shows the device type, name ip address. Is there one for IOS commmand line?
My senior network engineer wants to connect 12+ switches and routers through there respective console cables to a center point in the Network room and then access them through a PC or Laptop.Has anyone attempted this and what equipment did you use?
TACACS setup present
aaa group server tacacs+ tacacs_admin server server !aaa authentication login default group tacacs_admin localaaa authentication enable default group tacacs_admin enableaaa accounting exec 15 start-stop group tacacs+aaa accounti...
Rob,Thank you for your help but I tried that before I even posted here in the forums. The switch does verify the port and I have tired that commmand many times to no effect.