Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Guys,How do I make a route be preferred by one AS over another. My issues is as follows:I need to adjust the routing here so that all traffic to the 208.203.222.64 network goes out over the T3 AS 65203. As you can see from the Tracert its now going o...
Hi guys,I have an issue with a remote site. it routes traffic to my primary site via a backup tunnel rather than the neighbor MPLS site. I cant see why this is happening. Please see the below config snipt and see what I'm doing wrong. My knowledge of...
Hi,I need to monitor traffic on a Voice deditacted Vlan my network. I have set up a port on a 2980 switch with the following command:set span 11(vlan) 2/28 and have connected a desktop to this port and am running ethereal on it but i am not getting a...
Hi all,I'm trying to set up a backup router to my primary 7206. The 7206 takes care of everything at the minute so I want to run my VoIP traffic over the 2821. I've got a few different IOS but none of them allow me to put the following commands onto ...
Hi,I have an AP1220 configured connected to trunk port on a 2980 switch. On the AP i have it setup like this on the Dot1Radio0 Interface:interface Dot11Radio0 no ip address no ip route-cache ! ssid Internal vlan 7 authentication open guest-m...
guys thanks for the help on this.I'm tying to get a good understanding of BGP. Do you know any good texts or simulators\examples i could look at to get some experince with it.Thanks again,Rob.
Guys,it appears this is now resolved. The following line was removed from the config:neighbor 192.168.7.181 soft-reconfiguration inboundand i think this has fixed it. any idea why this would be the fix?
