What is the command to find the mac address-table on a ASR 9k? Sh mac...isn't doing anything. sh l2vpn forwarding.....isn't doing anything and I'm new to ASR 9ks.
Asking because I'm curious. We tend to have a good understanding of how many CCIEs there are because we can see on LinkedIn or places when someone celebrates and gets their CCIE number, but (ballparking) how many CCNPs are there in the world? And ver...
I am having trouble trying to find a CLI command that will let me config a WLAN/SSID into 5Ghz only: Radio Policy : 802.11a onlyI've tried the GUI disableing the 2.4, but I'm still getting: Operational State of Radio...
I've been the given the task (which I've never done before) of mac filtering on a couple of Ethernet ports for our meeting room. I'm getting confused by what I'm coming across on Google searches as I have about 200 or less mac address' I need to add ...
I have tried all the commands I could from your link but I am not generating a mac address-table from them. I don't have a BVI, so those commands aren't helpful.
I think you were nice enough to have a look at these yesterday and saw the one in 802.11a only. I'm just trying to figure out how to get the other the same. #sh run | sec-Managedaaa authentication dot1x DOT1X_AUTH_-Managed group _Managed wlan NPS--Ma...
Thank youThe one on 802.11a only:show wlan all | sec wlan id 10|Configured Radio Bands|Operational State of Radio BandsConfigured Radio Bands : AllOperational State of Radio Bands2.4ghz : UP5ghz : UP6ghz : DOWN (Required config: Disable WPA2 and Enab...
Right, and I've done that. But when going in to read the configs 2.4 still shows as UP: Operational State of Radio Bands 2.4ghz : UP 5ghz : UP 6ghz ...
