Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,
I am trying to have this simple setup with one 1841 router and one 8 port 2960 switch. I've got two ADSL connectivity and planning to terminate both in the switch with two different VLANs (VLAN 100 & 200). The third VLAN (VLAN 1) would be ...
I've a setup where the customer is using 1905 router for Internet access. They have a LAN segment with 192.168.1.0/24 and an WAN segment of 150.129.126.168/29 provided by ISP.
Right now they are using a D-Link router for internet access and its worki...
Hi,
I do have a recent requirement of few APs in a customer site. Previously they were using Cisco 1500's along with Cisco WLC at their site. But recently they came up with Zonedirector 1112. Now they are upgrading the same to 1150. Recently request ...
Dear All,Recently while downgrading our ASR 9006 from 5.3 to 5.1 we are getting a continuous loop. The system is not booting up. Could anyone help in this regard. I have attached the error output.Please note that we have used USB device for this purp...
Now you would not be getting 25mbps bandwidth exactly. What you could do is to divert your specific traffic to use one particular ISP at any given time. It would in turn lower the load on any one ISP.
For the same you could use any router with IP SLA...
Cisco 2960 are L2 switches. In any L2 switch, if you have to carry out inter vlan routing, you need to connect it with a router (L3 device). Intervlan routing would be carried out by the router.
Just configure the port connecting to the router in Tru...
Hi,
Problem here is basically with the routing part in between inside and outside facing ports in cyberoam.
As you could see that its not routing your packets from XX.XX.8.18 /20 to YY.YY.180.9 /28. Your firewall is probably working in bridged mode....
Hi,
I would suggest you to change the boot priority of the switch if it is having two IOS.
switch(config-t)#boot-start-marker
switch(config-t)#boot system flash: new IOS
switch(config-t)#boot system flash: old IOS
switch(config-t)#boot-end-marker
swi...
