Hello,I have Cisco 7304 router with SPA-2XOC3-POS and sfp module in it.Show inventory for this sfp:NAME: "SFP 3/0/0", DESCR: "OC3 SR-1/STM1 MM"PID: TRPD03MM3EAS-CS , VID: A , SN: OCP....show hw-module subslot 3/0 brief opticsShow brief info for s...
Hello,Does anybody knows where I can find Router Performance table in pps?Few weeks ago there was a Portable Product Sheet - Router Perf document on http://www.cisco.com/warp/public/765/tools/quickreference/routerperformance.pdf but now the paga is g...
Hello,I have problem/questions with cisco 1841 with adsl wic and HWIC-4ESW. Router is a CE router in IP VPN network. ADSL is a WAN link to PE router , first Eth is to connect different router. Client wants to connect three PCs and his own LAN network...
Hello,Our clinet would like to implement corporate network with VoIP (max 3 phone calls) over 256 kbps symmetrical, guaranteed ADSL link and don't spend too much money. I am littel concerned about VoIP QoS over ATM ADSL link. We plan to propose cisco...
Hello,I am looking for the smallest/cheapest Cisco router with minimum 4 Ethernet ports and one serial port. All Eth ports must have layer 3 functionalities.Could you propose one?Regards,Jarek.
I have checked this site:http://www.cisco.com/en/US/partner/prod/collateral/modules/ps5455/ps6579/product_data_sheet0900aecd80285547.htmlSFP-OC3-MM multimodeSFP-OC3-SR singlemode"OC3 SR-1/STM1 MM" has SR and MM phase that's I am confused.Are you sure...
Thank you for your message. Tell me if I undersood well.Lets say client has 192.168.0.0 network address in his LAN - I assigne 192.168.0.1 IP address on the Fe1 interface (onboard Eth interface - default gateway). Is it somehow possible to use 192.16...
I have seen this wic befor but I have question about configuring this wic - is it possible to configure ip address on these eth ports?? I need to run routing protocol on these interfaces.