Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, sorry for more questions but my head is spinning trying to configure the embedded AP on my Cisco 1111-4PWE.I have reset it and can access the AP console. I have setup a DHCP pool (with the option 43 and the IP address in hex).I've tried to correc...
Hello, I have an ISR-1100-4PWE with the embedded AP - isr-ap1100ac.I need to reset the AP's password (I can access the router itself fine). I have tried the command - hw-module subslot 0/2 error-recovery password_resetbut this doesn't seem to do anyt...
Hi, I'm getting a surplus C1111-4PWE .Can the embedded WiFi AP be used independently, or will it only work when connected to or controlled by a separate Cisco controller?
Hi, I have C 4321 routers and a problem with a PSU. Does anyone know the pinout for a temporary solution?The 6 pin socket is marked 12v and 54v - I assume the 54v is for PoE, and the router operates on 12v only?Cheers!
Hello, I discovered that for myself, thanks... Using the 'day 0' configuration I initially incorrectly setup a static IP and the AP would not route to the internet, so I reset the AP and configured DHCP correctly, and I am now posting this whilst con...
To address your reasonable comment, to my mind my request was sufficiently different to merit starting a new thread (and might have got lost in the noise). Thanks for your responses, anyway!
OK, thanks. It is actually much easier than I was trying to do - pretty stupid to try to apply the 1941w instructions to the C1111. I've done the three relatively simple steps and am now connected to the wireless. Not yet fully working but I think it...
Hi, maybe it's premature to try and login via the Web GUI. Currently the module is saying 'waiting for preferred uplink IP address' and repeating that message every 30 or so seconds.Please advise!
Hi, I think access via the WebGUI is premature.Here is part of the boot-up messages - the module keeps on saying 'waiting for preferred uplink IP connection'. Can you advise please?e: [*07/29/2024 23:01:52.9399] click-config/io-real.click:141: While ...
