Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Could you please advise if i can get the Attendant console client software and used it with the CUCM version 11.x ? I'm trying to link some Directory Numbers to the software so that the receptionist may answer call from the loaptop.
I'm trying to recover the password on the VG204. Since "reload" command is not supported, i'm forcing a hard restart (unplug/replug PSU) while making sure to send "Break" key during intial bootup. But still, i'm unable to enter ROMMON Mode. Could yo...
Thanks a lot for your clarification. We currently have the CUAC server deployed but seeing how its configuration is a bit complex i was wondering if we could just use the standard version of Attendant Console. * Could we use the software and set it u...
Hi Roger, thank you for following up. I'm still not sure if the VG gets the break as it seems to be directly initilized. I tryed using an old keyborad that contains the "Break" key but the behavior is still the same. As shown in the below screenshot ...
Hi Nithin, Thanks for following up. I acquired an old keyboard that contains the "Break" key. But the behavior is still the same. I cannot access ROMMON mode as the VG seems to be directly initilized.* screenshot attached
