Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have Catalyst 4900m running at "cat4500e-entservicesk9-mz.122-54.SG1.bin" image. I setup this 4900m to be wireless network layer 3 router. However, recently the switch start logging %C4K_EBM-3-CANTALLOCATEVLANHOSTENTRYbased on http://www.c...
Hello all,Got a question for 4900m with TwinGigi Converter. I bought couple TwinGigi Convert thinking to use it on fix module ports (8 * 10G ports on 4900m ten1/1 to 1/8). I follow TwinGigi configuration guide http://www.cisco.com/en/US/docs/switch...
Hello All,I have question regards to Cisco TelePresence... We just acquired two set of Cisco TelePresence System 500 however, we are running Aastra Clearspan VoIP solution in our compnay.... So my question is:1. Can I use Cisco TelePresence System...
Hi All,Got a question about flow-export to to vrf Mgmt-intf.asr1000 version: 02.06.02.122-33.XNF2ip flow ingress on both inbound and outbound gig interface.additional commands:ip flow-cache timeout active 1ip flow-export version 9ip flow-export dest...
Maybe its by design but just my curiosity since this our first 10G line card... After insert 10G and put in production, when I ran show mac-add from 10g interface I only see list off mac address from module 9 (slot i had 10g line card insert). but ...
Hi Vignesh,Thanks for promptly reply. Here are some output. Plesae know regards to Mac flapping. Since I use this as wireless router and yes, user mac will moved from one port to another port when user roaming. So far I don't see hundreds or thou...
Thanks for promplty repsond. We also have Cisco Gatekeeper in house and I am not sure if I can use it to setup video conference between two Cisco TelePresence System 500? Also I am wondering is there a way for me to using these two TelePresence wit...
Hi KK,Thanks for promptly reply. The bug is fixed in 12.2(18)SXF11 but I am running 12.2(33)SXH6.. Also do you know why I can only use 9216 in interface config mode? Why I can't use as range such as <1500 - 9216> ?Thanks,=J=
